Home / Issue 36

Browsing Tag: Issue 36

How do you center a hole saw in an empty space? Fill the space with a bung first. Then drill your new, larger hole.

How to enlarge an existing hole Issue 36 : May/Jun 2004 How do you enlarge an existing hole — whether for a through-hull fitting, a finger hole in a drawer, or plumbing to go through a bulkhead — with...

For $50 and a bit of effort, Bob Steadman was able to replace the short spigots in his galley sink with something tall enough to work well when filling or washing a pot.

More reach, more height in the galley sink Issue 36 : May/Jun 2004 I love the foot pumps in my galley. Not only do they provide precise control over water consumption, they allow the use of both hands...

Mealtime in the cockpit can be vastly improved if you don’t have to have one hand for the boat, one for yourself, one for your sandwich, one for your drink . . . A portable tray that wedges securely in the footwell and can fit on the gimbaled stove during food preparation time makes life much simpler.

Neater and tidier dining al fresco Issue 36 : May/Jun 2004 Eating lunch in the cockpit while under way can be an ordeal. The boat heels, drinks spill, sandwiches are sat upon — or slip off the seats a...

Just a few of the many common ingredients found aboard ship that can be used to make a multitude of homemade cleaners/polishes.

Good old boat-cleaning recipes use cheap, natural ingredients Issue 36 : May/Jun 2004 We live on a farm in rural, northeastern Ohio, nestled in among the fourth-largest Amish community in the world. A...

Making a screen bag is easy. Cut screen and trim (Figure 1). Install drawstring and grommets and sew the trim to the screen (Figures 2 and 3). Sew up the sides and enjoy the finished bag (Figures 4 and 5).

An easy, low-cost project for the beginning canvasworker Issue 36 : May/Jun 2004 Screen bags are an elegant solution to a couple of age-old problems aboard our little sailboat — namely where do we put...

The front of the J. R. Overseas moisture meter, above, shows the moisture scale, while the back side, at left, shows the sensitive sensors.

A marine surveyor’s best friend Issue 36 : May/Jun 2004 A moisture meter is a marine surveyor’s best friend, but do you need to own one if you are not a surveyor? Basically there are two types of mari...

Illustrated title card

A woman singlehander loses her heart to that old lump of iron down below Issue 36 : May/Jun 2004 Most sailors don’t miss the motor after they part with their first auxiliary-powered sailboat. Bu...

Cable-and-sheave steering system

Eight ways to steer a boat Issue 36 : May/Jun 2004 When it comes to steering a sailboat, even die-hard wheel enthusiasts agree there is no steering system that is simpler, more affordable, or offers b...

Figure 1. As a means of taming a rudder whose steering mechanism has failed, the relieving tackle, shown here, suits some situations. Two outer blocks are fixed to the boat, and the two others are attached to the ram tiller or quadrant. Then tension is applied at a jam or common cleat (which can be mounted on a bulkhead or similar surface). This is not a steering device — merely a way of arresting an active rudder while an emergency tiller is found and fitted.

Be prepared for the worst and hope it never happens Issue 36 : May/Jun 2004 Oof the many steering systems available to the small ship, none is easier to make, simpler to use, or more sensitive to the ...

A deadeye, above, a bulldog clamp, center, and a swaged fitting, at left.

What’s at the end of your shrouds and stays? Issue 36 : May/Jun 2004 The stainless-steel standing rigging that supports our masts is critical to our sailing safety, and the terminals at the end of the...